Getting sound from the Sansui TV to the Genessis stereo
You will need a stereo cable (red and white with RCA jacks ).
Attach this cable to rear of TV audio L / R output. see page 13 of manual.
drop cable to bottom and set aside.
Now I set up a small table to slide the Genesis stereo on to.
There are covers on each side of the stereo covering the screws.Remove these with a small screw driver.They come off towards you NOT sideways.
Look in the screw holes so you know where the screws are and remove the screws (4).
Attach the end of the stereo cable to white AU2-L and AU2-R .
Get your bearings by noticing where the 4 yellow sockets are. AU2R and AU2-R are in the bottom corner looking at the picture on page 28 of the Genesis GT-20 manual. Note** they will be upside down on the unit!
Put it back together and turn on the TV.
Turn on the stereo and set the input to aux 2.You should now have sound to your speakers. SUNSET TRAIL 250RB
Thank you. I don't have that particular radio/camper but I'm going to check out my set up on my Jensen and see if I can do something similar... At least until I upgrade the whole crappy system!!!
__________________
2014 Ram Big Horn CC 1500 tow package, 3.92 gears.
2016 Crossroads ST270BH (June 18, 2015)
(2015: 7 nights camping, 425 miles) (lost track and became too lazy to update!)
I did the same thing to our Jensen unit. I then had to go to the TV menu and turn off the internal speakers and turn on the external speakers, and push AUX on the stereo. 📺📻
__________________
🇨🇦 Scott & Janie 🇨🇦
2004 Dodge RAM 2500 CTD (slightly tweaked)
2011 Cruiser 31RK
Cooper the Golden Retriever, and
Sam the black lab.