suspension upgrade

[railroadmichael]

I have a 2005 29RK and am going to put the greaseble pins in the suspension. Does anyone know if the grease zerk on top of the equalizer on the curb side will interfere with the gas pipe that runs along the frame and through the equalizer hanger. Thank you

[harley]

If it does , put the bolt in from the back side.

[Lloyd]

The gas line on mine runs along side the frame. Doesn't go thru the hanger. Even if it did, I can't quite picture how it would interfere with the grease zerk. That comes out the end of the bolt.

[railroadmichael]

I guess I did not make myself clear (sorry) The grease zerk is in the top of the equalizer itself. This particular hole does not take a grease pin. The manufacturer has tapped a hole in the top of the equalizer so the grease zerk is located in between the hangers for the equalizer. I guess I could order a gease pin for that hole and plug the hole threaded into the equalizer.

[Lloyd]

What have you got for an equalizer? Mine is the Equa-Flex by Trailair.

[harley]

How about a 90 degree grease fitting?

[railroadmichael]

I have a standard shaped equalizer with the brass bushing already installed. This has the zerk factory installed and it is a 90 degree application. I guess I will have to install the suspension components and just see if the zerk is going to foul the pipe. My original thought was that if someone had already done this and found it to be a problem that they might already have the solution. Thank you so much for all the replies.