Corner stabilizers

[Beebee381]

Hello all
I have a 2014 Crossroads 26RB Reserve. On my last campout I was packing up to leave. I have the motorized corner stabilizers. As I was bringing up the front two, a shear pin fell out and landed on the pad. Luckily I saw it fall. Well the stabilizers came up, but would not go down. Motor just spun. So when I got home I crawled under the beast and with the help of my blushing bride was able to hand crank the stabilizers and line up the hole for the pin. Tap of a hammer and it slipped back in. So then I wrapped several layers of tape over the pin to hold it in place. Did the same to the rear one. I mainly posted this as a heads up to people. You might want to peak under your TT and make sure your pins aren't slipping out. There are two of them located where the worm gear attaches to the motor.

Bill

[ewbldavis]

Good info. I will share with friends that have power jacks (even though other brands).

[Tim D]

Originally Posted by ewbldavis

Good info. I will share with friends that have power jacks (even though other brands).

...X2. Thanks.

[ewbldavis]

Are you following me Tim? LOL

[Tim D]

Originally Posted by ewbldavis

Are you following me Tim? LOL

It appears that way.

[Beebee381]

I have to say that the hand crank is 20 times faster than those slow motors. If something breaks again I'm just going to use a cordless drill.
Bill