I recently purchased a used 2008 Cross Roads Sunset Trail 26' with a 10 foot slide out. I have a manual crank handle but can not find the hole to insert it to manually open or close the slide. Can anyone tell me where it is?
Look on the opposite side of the rig from the slide in question. There will be a 1" hole for the crank. Use caution as the tee "pins" tend to break easily.
I've looked under the trailer on both sides. Under the trailer is completely sealed. Not even the frame is exposed. I'm going to feel real stupid when I do find it!
Take a look by the entry steps, one of mine is located there
__________________
Frank and Janet Henn
2000 Monoco Lapalma
being pushed by a 2004 Jeep Grand Cherokee
Traveling with Rainbow the wonder dog and now with Sunshine the rescue Schnauzer.
We have a 2015 25RB. Our entry point is inside. When facing the slide, look in the upper middle if the woodwork. Probably six to eight inches down from the top of the top of the trim piece. Our unit is in storage, otherwise I would send you a picture. Good luck.
Eric Malm
__________________
Eric & Ginny
Daisy the Boston
2015 CR Sunset Trail Super Light ST 250RB
2013 Toyota Tundra Double Cab V8 5.7 Ltr Limited
Do you have the cable driven slide out? If so, there is an access panel on the head rail of the slide out facia, and the trailer should have come with a 10 - 12" long, square drive. You attach that drive to your cordless drill and insert the square drive into the slide motor and run it that way.
__________________
2016 Sunset Trail 33BD
Tow Vehicle 2016 Nissan Titan XD 4x4, Crew Cab, SV with Cummins V-8