I got this idea from someone else here but figured I show how I did it.
From my blog.
I really like awning lights that hang from the awning. I have some rope lights that give off just enough light to give a nice glow to the patio without attracting bugs. The problem is the can be a pain to take down quickly if you have to retract the awning I got this idea from someone on the Woodalls forums and thought I show you how I did it.
I took two pieces of aluminum angle and cut them about 2" long. I then drilled two 1/8" mounting holes in the aluminum angle and a 5/16" hole in the other leg for the wire attachement point.
I then pop riveted the aluminum angle to the outside of the awning arm. The 2" length is long enough to give a good stable base for the mount. What you have to watch here is the placement. It needs to be high enough so your entrance door will not hit it but low enough so it will not get caught by the awning material when the awning is retracted. For me this was having the wire support hole about 2" below the empty awning roller.
![](http://www.tgifrv.com/wp-content/uploads/2011/10/AwningLight01-640x426.jpg)
I then purchased 25' of 1/16" stainless cable (I have a 21' awning), a small turnbuckle and a couple of cable clamps. On one end I looped the cable through the turnbuckle eyelet and used the cable clamp to secure it. I then used a Carabiner hook I had laying around on the other end of the turnbuckle and attached it to one of the aluminum angles.
![](http://www.tgifrv.com/wp-content/uploads/2011/10/AwningLight02-640x426.jpg)
On the other end I just made a loop so the length of the cable was just long enough so I could use another Carabiner on it and hook it to the opposite angle mount. Once both ends are hooked You can then use the turnbuckle to tighten the cable.
![](http://www.tgifrv.com/wp-content/uploads/2011/10/AwningLight03-640x426.jpg)
I then used tie warps to attache the rope light to the cable. For now I have a couple plastic hooks I use to attach the rope light to the awning arms but am looking for another way to attach them to the arm so they won't get in the way when the awning is retracted.
![](http://www.tgifrv.com/wp-content/uploads/2011/10/AwningLight04-640x426.jpg)
You can now retract the awning without removing the lights. Nice for when you leave the campsite and want to put the awning up or if it gets windy. Before I pull out of camp I just loosen the turnbuckle, remove the cable with attached rope light and pack it away.
Edited by: hhh