Is there a way to adjust gas stove?

bradswife · 11-17-2013, 01:57 PM

When I have the gas on low it's too high to simmer. We asked our dealer yesterday and they said there was no way to regulate it. Do you have any suggestions? We have a 2014 335ss.

Livewire · 11-17-2013, 02:13 PM

Not sure and our trailer is put away for the season,but on our house range if you pull off the control knob there is and adjustment screw in the centre.

socoguy · 11-17-2013, 04:20 PM

Quote:

Originally Posted by Livewire

Not sure and our trailer is put away for the season,but on our house range if you pull off the control knob there is and adjustment screw in the centre.

X2. It is a low flame adjust screw. I also don't know if it is the same on the RV propane range. (Rig is stored).

RJHewitt · 11-18-2013, 05:08 PM

Our stove igniters only work half the time. I can't use the same burner, it won't light. Any ideas? The gas is going to the burner, but it won't light it'self all of the time. This happens on all burners.

Thanks!

ewbldavis · 11-18-2013, 05:44 PM

Most of these stoves have a single ignitor in the center. You may try turning burner on, count to like 2, and turn ignitor nob. This gives gas time to go down tube to the ignitor.

DON"T WAIT TOO LONG!! About 2 seconds is all you need. "Click" it a couple times.

sking · 11-18-2013, 09:31 PM

The stove has it's own regulator that can't be adjusted but could be bad. You could get a regulator that will flow less gas but that will affect your high output. RV stoves are non adjustable except for fuel/air mixture.

sking · 11-18-2013, 09:35 PM

RJ you can adjust the position of the igniter and that may help you out. Sometimes it's a little to far away from the gas.

NBtraveller · 01-04-2014, 06:48 AM

Our igniter almost never works. We use a BBQ lighter. It's easier than fiddling with the stove.

p4lrjfd · 01-05-2014, 05:40 AM

The front burner on our 3 burner stove is a bugger to light. Sometimes it will light on first "click" of igniter, but usually won't light after 8 or more "clicks". There is a spark and there is gas. This is the high output burner I think. There is an igniter built in to each burner that is not adjustable.
Anyone else had this problem, and if so any success in fixing it?

You may also like: