Tilt Slide out

[danyshula]

The big slide with the dinning table and the hidabed is leaning a bit down when it is open,the beam under it is touching the lower part of the hole on the frame so when I move the slide in/out it scratches the beam.
Any suggestions besides going to an RV repair that I will be doing soon?
Thanks

[Dayle1]

Dan,
You can loosen the bracket bolts and adjust the vertical bolt to lower the slide out floor. This reduces the distance between the beam and the slide out floor. When the slide out is fully extended tight against the main wall, this will actually lift the beam slightly and may solve your problem. But if the beam is dragging on the frame cutout more than just the last few inches of travel, then more significant repairs will be needed.