Furnace doing nothing
Currently on our first trip of the year. Once we got setup at the campground, walked inside and noticed that the RvComfort.ZC thermostat displayed Zone 4 and 00 where the temperature normally is. Now the weird thing about that is that I wasn't aware that I had a Zone 4 because all I have ever used is Zones 1 & 2 for the cooling A/C's.
Anyway, I "reset" the thermostat by pulling the fuse and after several false starts got it displaying Zone 1&2 like it normally does.
Well, the first morning we got up, it was a little chilly so I slide the switch to Heat and..........nothing happens. No clicks, no blower, no nothing.
Did some googling and found out how to put the thermostat in "programming" mode. The problem is that it only recognizes Zone 1&2 (both cooling zones) and nothing else.
My thoughts/questions:
1) I'm thinking the original Zone 4 was setup as the "Heat" zone and the original 00 displayed was trying to tell me something (like maybe the thermostat realized that the Furnace wasn't present any longer.
2) I have checked all of the fuses (none are labeled "furnace", flipped the one switch on the furnace that I can get to, and tried everything I can think of.
3) I cannot figure out how to get a good look at the board in the furnace housing. It is next to the water heater and the only access I have tried is to remove the metal return duct. Unfortunately, that still doesn't get me any access to the circuit board.
Any help. thoughts or suggestions would be most appreciated!
__________________
Barry
2014 Sunset Trail Reserve 32RL
|