Anyone know what type of furnace screen I need for my Sunset Trails ST28BH? The furnace is an Atwood Hydroflame, but looking on Camping World's website, I'm not sure which flying insect screen will fit over it best. Thanks!
Hello folks! I'm still looking for an answer to this one. I purchased a flying insect screen, only to take it out of the box and find out it's too small. If anyone happens to know which one they used, I would greatly appreciate it.
Hubby and I need to update our signature. Our current camper is a 2014 Sunset Trail ST28BH travel trailer. And we are LOVING it!!!
Wild West thanks so much for your reply! Unfortunately, it's not two round vents on this furnace. It's just one round hole with a square metal frame. Maybe someone with a 2013 or 2014 Sunset Trails Reserve would have the same type of furnace vent??
Hello Edge1...were you successful at finding the proper covers. I believe I've picked the right ones to order for my Hot Water and Furnace but am curious about the oven outlet, the pertruding circular on near the entrance door. Any suggestions?
I have a 2015 Sunset 290QB
It installed easy and has not come off! We nave not, however, done anything with the hot water cover or the fridge. We put in the recommended 1/2 flea collar and bay leaves in both areas. The fridge one was easy as I just stuck them in a baby food jar and used some sticky-tac puddy to hold it in place. However, the hot water heater area is too narrow for a baby food jar. So I just bundled it all together with a twist-tie and put it in there. It's pretty dried up now - probably time to replace them all after 12 months anyway.