Looking to see if anyone has experienced or has insight on a slide issue i'm having.
2017 Sunset Trail 289qb with the Norton BAL cable slide system. When running slide in and out the slide violently vibrates up and down like its dragging on something. It's wearing at the tarp wrap underneath on the outer edges.
I pulled the piece of trim down to look at the slide cables and everything appears adjusted at least no crazy slack in the cables and the motor seems fine going in and out.
If I can't resolve it I plan to get it back to the dealer after our July 4th trip.
Check under slide, Make sure rollers are clean & clear. Path of rollers is free & clear of everything.
Lastly check rollers are rolling. Factory has poor(non-existent) QC & rollers get installed incorrectly . . .
Check under slide, Make sure rollers are clean & clear. Path of rollers is free & clear of everything.
Lastly check rollers are rolling. Factory has poor(non-existent) QC & rollers get installed incorrectly . . .
That's the direction I was leaning. Any insight on how to get at those things...I'm assuming the removal of the lower slide seal sweep is necessary to look in underneath the slide?