Tv mounting question

[Larry12]

I recently purchased a zinger 280bh

It did not come with tvs. Does the mounting area have a stud i need to hit? Or is the entire area plywood?


Thanks

[Akenny]

Hi
There should be a stud that you need to use for mounting.
Use a stud finder to locate or just by pushing in the thin plywood and tapping with a hammer.
Once you find it, I recommend putting a 1/2 inch or 3/4 inch piece of plywood on the wall using the stud. 12 inch by 12 inch should be lots.
This will give you lots of room to install the wall hanger without going through into the finished cabinet which might have wires in it.
If you install the bracket on the plywood first, you can use bolts for additional strength and no damage to the wall.
Painting the plywood black or brown first will help hide it if you tilt the tv...
Good luck...

[Rrizz]

That is a good piece of advice.

[sleepyT]

Originally Posted by Larry12

I recently purchased a zinger 280bh

It did not come with tvs. Does the mounting area have a stud i need to hit? Or is the entire area plywood?


Thanks

Larry
Most of these new campers have a piece of plywood mounted between the studs to mount your TV...They also usually have a sticker on the wall that states this is an area to mount your TV...I am not familiar with your model but maybe someone on the forum who has the same model as you can send you a picture of their mounting area...Lastly have you asked your dealer about the TV mount area...