Water Leaking and Underbelly Questions
Hello all, we did a bleach water system flush today on our 2010 Zinger 19RD. While flushing the water through, suddenly it poured out of the drainholes (sewer outlet connection, etc.) and started pouring out the underbelly, both on the edge of the trailer by the drainholes and a bit in the middle where the sewage pipe comes out of the underbelly of the trailer. I am wondering if this might be an overflow issue from filling the water tank too full, a pressure issue from using a hose to do this, and/or a crack in a pipe along the way. No water inside the trailer anywhere.
We'd like to investigate this further (comments welcome), but can't seem to get to the water tank itself. I am assuming we will have to go through the underbelly, but can't figure out how to get it off without tearing through it. There seems to be a small separate section of underbelly about a foot wide between the outer edge of the trailer and the main frame above which the tank would be located. Is there a way to open that up without cutting it? Or are we best to cut it and use something like gorilla tape to repair it? We would like to get the wet insulation out as well. Thanks!