Where to get new graphics

[Robldoit]

Can someone direct me to a vendor that will have replacement graphics for my 2011 Crossroads Cruiser Patriot. I found a couple vendors but not for a 2011
Thanks Rob

[Lloyd]

If you have a graphics guy in the area that puts decals on trucks/etc. I would talk with them. They usually can duplicate just about anything.
CR doesn't seem to keep replacement decals on hand for very long.

[Stan]

Try RVDECAL.com in Arizona. I have used Steve several times and they come out real good. He has some in stock (main logo etc) but for others you take a straight on picture and he duplicates the decal from that. Not perfect but really close.

[mopa98]

My question is how do you get the old cracking decals off?

[mark5w]

Here's a way: https://www.rvrepairclub.com/article...ecals-from-rv/

[Yakherder]

You can also try this link https://www.rvdecalsdirect.com/ as they may have what you are looking for.

[drzaius]

Even if Crossroads had the replacement decals, would you really want to put those low quality things back on? Talk to a local shop that can supply 3M decals. They'll last much longer.

[Stan]

To remove the old decals, I used a heat gun on LOW heat IF the decal is intact (not cracked). If the decal is totally cracked then I used a pinstripe rubber wheel for the drill motor. They are available from a few different manufacturers on Amazon. These are what professional auto repair facilities use. It is time consuming but will not damage the siding.

[Jeffur]

I used gasket remover, product was called Chisel. Be careful of over spray as it will eat the filon gel coat. I mask off the areas / tape alonghe edge of the graphic and then spray. Remove the decal in one minute and wash the area with sips and water. Keep this bucket handy. The process will remove everything, including the glue residue. I then compound the area to try to blend the colour. I did my 2011 Seville. My vinyl graphics company worked from pictures and measurements of the actual stripe. It came out great