Dinette Table Issue

[mww1969]

I have a new CR Volante 32SB. The dinette table is unstable and has the tendency to fall with any weight on it. This model has a female V-channel bracket mounted underneath the bench and the black channel connected to the table has a male V-channel bracket attached.

I am fairly sure that the bracket mounted underneath the bench is mounted too high to allow the table bracket to seat properly.

Anyone else have this issue? If so, what was the solution.

Mark
2021 Volante 32SB

[Lloyd]

Can you post a couple pics?

[dagst1]

So i looked at some pictures of your camper and the table was on a pedestal. Are you talking about when you lower the table to the bed position?

[Wingerdinger]

We could use some pictures. The pictures on the Crossroads website don't show that arrangement at all.

[Cbarnesatc]

There appears to me that there is also a screw hole down there in which to insert a screw and snug it up against the support arms. I may be mistaken.

[B_clark26]

I ha e the same problem with my new Valonte. The table is wobbly and falls over constantly. Almost landed on my 2 year old the other day. Seems like there should be a base or some way to secure it before someone gets hurt.

[Soupsandwiches]

anyone find a fix for this issue yet? Same camper same problem here

[Lloyd]

Originally Posted by Soupsandwiches

anyone find a fix for this issue yet? Same camper same problem here

Like so many do, the OP came on here and asked a question and we never heard from him again.

I see there is one or two other posters with the same rig. Maybe one of them has an answer to it.

[Soupsandwiches]

Originally Posted by Lloyd

Like so many do, the OP came on here and asked a question and we never heard from him again.

I see there is one or two other posters with the same rig. Maybe one of them has an answer to it.

I'm going to reach out to crossroads and hopefully get an answer. Seems to be enough of us with the same issue. I'll respond if I hear anything.