CrossRoads RV Family Forum

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Dayle1

Forum: Rushmore

05-08-2016, 08:24 AM

Replies: 7

Holding tanks monitor and external speakers not working

Views: 2,786

Posted By Dayle1

A single sensor works for the fresh water tank. ...

A single sensor works for the fresh water tank. You don't need to drop the entire underbelly, a corner in the rear and along one front side. I can't tell which will work best for you, it depends on...

Forum: Rushmore

02-07-2016, 10:59 AM

Replies: 7

Holding tanks monitor and external speakers not working

Views: 2,786

Posted By Dayle1

As I indicated, I used the existing sensor wires...

As I indicated, I used the existing sensor wires rather than pulling new ones. In fact the SeeLevelII only needs a single wire plus ground to read all sensors. You shouldn't need to drop the entire...

Forum: Rushmore

02-01-2016, 09:51 AM

Replies: 7

Holding tanks monitor and external speakers not working

Views: 2,786

Posted By Dayle1

I Did the install myself. Sensors attach to the...

I Did the install myself. Sensors attach to the Outside of each tank. Existing wires can be used and the display located near the factory display

Forum: Rushmore

01-31-2016, 08:39 PM

Replies: 7

Holding tanks monitor and external speakers not working

Views: 2,786

Posted By Dayle1

Just about everyone uses the cheap tank monitors...

Just about everyone uses the cheap tank monitors and even if they work, they won't work for long. Some RVers go to a lot of effort to keep the sensors working. And, there are a few aftermarket...

Showing results 1 to 4 of 4

Forum Jump

Disclaimer:

This website is not affiliated with or endorsed by Crossroads RV or any of its affiliates. This is an independent, unofficial site.

All times are GMT -6. The time now is 03:51 AM.