![Reply](/forums/images/crv/buttons/reply.gif) |
04-08-2012, 03:38 AM
|
#1
|
Weekend Camper
Join Date: Feb 2012
Location: Southern Louisiana
Posts: 70
|
We just purchased a new Rushmore that has the keyless entry door lock installed. Everything works just fine but in looking over the operating instructions that came in the information packet there is a small section that talks about replacing the battery in the transmitter (keypad). We do not yet need to replace it but need to know what to do when that time comes.
My specific question is how do we get the keypad off the side of the unit? There does not appear to be any screws holding it and I don't want to pry it off if that will damage something. How is it attached?
Thanks,
Robert in La.
|
|
|
04-08-2012, 04:27 AM
|
#2
|
Family Vacation Member
Join Date: Jan 2012
Location: Owen Sound, On
Posts: 117
|
I specifically asked the dealer about that when we had our wak through of our Provincial CF345RF and they showed me that it is hardwired in. the connection is on the door frame & door. Have a look and you'll see itabout a ft from the bottom of the door and door frame....
Therefore no need for a battery change unless of course the house battery goesdead........LOL
Come on warm weather........ really want to try this unit out but the Ontario weather isn't cooperating too much.
|
|
|
04-08-2012, 05:15 AM
|
#3
|
Weekend Camper
Join Date: Feb 2012
Location: Southern Louisiana
Posts: 70
|
Thanks, Speedster ... that makes sense to me but I was confused by the information in the packet. I saw the contacts at the bottom of the door and kinda thought it was hard wired. This is one item I missed on the PDI.
Robert in La.
|
|
|
04-08-2012, 08:12 AM
|
#4
|
Weekend Camper
Join Date: Feb 2012
Location: North Bay, Ont.
Posts: 34
|
On my Rushmore, I need to pull the keypad from the exterior wall, clean up the sealer, remove 2 small screws at the back of the keypad, replace the battery and then reglue the keypad using a two side gluing tape and then seal the top with clear sealant.
Givent the work required, use the best battery possible. I hear the battery will last 2 months average.
The dealer had to change it when we did our walk through back in March.
MM
__________________
2012 Rushmore 34SB
2009 Silverado Duramax 2500HD
|
|
|
04-08-2012, 08:30 AM
|
#5
|
Weekend Camper
Join Date: Feb 2012
Location: Southern Louisiana
Posts: 70
|
Hmmmm....maybe the Rushmore is different from the Provincial???
MM, from your reply I assume you just pried it from the exterior wall? If this is the case it sounds like I may want to re-apply with velcro to make it easier in the future.
Thanks for your help.
Robert
|
|
|
04-08-2012, 10:16 AM
|
#6
|
Weekend Camper
Join Date: Feb 2012
Location: North Bay, Ont.
Posts: 34
|
Velcro is a great idea that I will use in my next battery change.
My keypad is on the left side of the door between the slide and the door at the level of the bottom of the foldable handle.
MM
__________________
2012 Rushmore 34SB
2009 Silverado Duramax 2500HD
|
|
|
04-13-2012, 10:53 AM
|
#7
|
Weekend Camper
Join Date: Mar 2012
Location:
Posts: 12
|
The Rushmore and the Cruiser are both the same as far as the key pads both take batteries and are not hard wired in, the rushmore is mounted on the wall to the left of the entrance door and the Cruiser is mounted on the door below the door handle. The contacts at the bottom of the door are for the led lights below the bottom of the door. Hope this helps.
__________________
Trailer Tom
|
|
|
04-14-2012, 02:18 AM
|
#8
|
Family Vacation Member
Join Date: Jan 2012
Location: Owen Sound, On
Posts: 117
|
Well that is strange as I specifically asked the question when walking through thesystems with the service guy at the dealership on our 2013 Provincial CF345RF..... He indicated it was fed from the house batteries.
Good to know otherwise but really strange they wouldn't have known that at the dealership?
I'll have to check it out whenthe weather warms up and we get out to the lake where it is parked.
|
|
|
04-15-2012, 10:57 AM
|
#9
|
Family Vacation Member
Join Date: Feb 2010
Location: Deer Park, TX
Posts: 227
|
Quote:
Originally Posted by Trailer Tom
The Rushmore and the Cruiser are both the same as far as the key pads both take batteries and are not hard wired in, the rushmore is mounted on the wall to the left of the entrance door and the Cruiser is mounted on the door below the door handle. The contacts at the bottom of the door are for the led lights below the bottom of the door. Hope this helps. ![](http://www.crossroadsowners.com/smileys/smiley20.gif)
|
The contacts located on the door & frame, are for power to the 12 vdc electric lock, controlled by a circuit board (reciever), operated by the battery powered keyboard (transmitter). The led lights are operated by a normallyclosed magnetic switch located in the threshold & the magnet that is mounted underneath the hinge side of the door. When the door closes, the magnet opens the switch, turning off the led lights.
__________________
Steve & Sharon
'13 Dodge Citadel (hers)
'12 3500 Dodge Mega Cab 6.7 Cummins (his)
'12 Crossroads Rushmore RF38FL (ours!)
Barry, the ADHD x 2 German Shepherd mix, Granddog.
|
|
|
04-15-2012, 11:22 AM
|
#10
|
Family Vacation Member
Join Date: Jan 2012
Location: Owen Sound, On
Posts: 117
|
Thanks great info........... so much easier to trouble shoot down the road when something doesn't work !
|
|
|
05-01-2012, 11:31 PM
|
#11
|
Weekend Camper
Join Date: Jan 2011
Location:
Posts: 37
|
RE the battery replacement, The keypad is not hard wired. The mechinism inside the dooris however. I have had to replace the battery in the keypad several times. The keypad is glued to the side of your RV and comes off with some pressure. There are eight small screws on the back side of the keypad and inside you will find the battery. You will need something to glue it back on the RV and some clear caulk to seal it from the weather.
CAUTION: Do not lock with the keypad and leave your keys inside the RV. I did and you guessed it. Battery dead. Had to get a locksmith. $100 lesson.
|
|
|
05-10-2012, 10:03 PM
|
#12
|
Weekend Camper
Join Date: Jan 2011
Location:
Posts: 37
|
I also had the battery replacement problem and once got locked out as I left the keys in the unit assuming I could use the keypad. It worked when we left but not when we returned( dead battery). I didn't think that the battery should last only two months so I called Southco ( the manufacturer) and was told that the battery should last for 4-5 years. Also, I was tole d that they had a production problem with them and my should be replaced. I contacted Lippert as instructed and they sent my dealer a new keypad. Jury's still out as two months have not passed yet.
|
|
|
05-10-2012, 11:12 PM
|
#13
|
Weekend Camper
Join Date: Feb 2012
Location: North Bay, Ont.
Posts: 34
|
Thank you for the lead. When I picked up the unit, they had to change the battery on March 9th and the batterydiedon April 20th so about 6 weeks.
I will try to find the contact at Lippert.
MM
__________________
2012 Rushmore 34SB
2009 Silverado Duramax 2500HD
|
|
|
![Reply](/forums/images/crv/buttons/reply.gif) |
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|