What i ended up doing.
I did mine out of 4 inch. w/ Rhino hose. Mounted front to back. My 4" Sliced in half are all put in the rear pumper. Made long ones and short ones to use for slinky support.
Filed off the tabs. The Rhino had huge tabs.
Mounted "L" brackets
Close up "L" brackets
Mounted PVC holder. Stainless hose clamps. 15 footer in each end
Front View
Drill holes in end nuts encase they get stuck (you can use a screw driver) and in the bottom of the pvc holder for water drainage..
Nice and snugly. Like it was supposed to go there.
Edited by: danskool