I finally completed some heat ducting modifications to equalize heat distribution, as follows; At furnace, I disconnected the ducts to the bedroom and bathroom. I purchased a "y" splitter and connected ducts to bedroom and bathroom to the output of "Y". I connected input to "Y" to one of the vacated furnace outputs. I purchased a 4" round vent , and installed in panel blank under TV near floor, and ducted this terminal to the other vacated furnace output. I had already installed vents with dampers in bathroom and bedroom. When I tested the install, I set Zone 1 thermostat on 70 degrees. The bedroom damper is closed, and bathroom damper was partially open. The result was the heat was pretty even throughout living area. Bedroom temp and living room temp were 71 degrees when furnace shut off. This is much better. The round vent I installed was a dampered unit, but I removed the damper assembly. The louvers are also able to be aimed by rotating the insert. I can live with this...
__________________
Jerry
2014 Elevation 3616 5er
2015 F350 6.7L Diesel 4X4 - long bed, dually
|