Stuck middle slide

Stew47 · 05-31-2018, 05:53 PM

Hi everyone. I have a 2010 cruiser 32bl. The small middle slide is stuck. There’s no hole to slide the cranking took from outside either. Any thoughts?

Papa-T · 05-31-2018, 06:02 PM

Small hole will be on the opposite side of the camper from the slide you want to crank. Unless it’s a bedroom slide and some don’t have a manual crank.

Stew47 · 05-31-2018, 06:19 PM

On the opposite side is the shaft with little pin and lol no hole to slide wrench in. So I’m gonna head to Walmart and get a hole saw

**mark5w** · 05-31-2018, 06:29 PM

Don't drill hole until you're sure what type of slide you have. If it is a Schwintek. look at this manual. CrossRoads RV Family Forum - Library - Schwintek Manual Override Instruction--Video

Papa-T · 05-31-2018, 06:32 PM

Good advice. If it doesn’t have the hole; more than likely it’s not supposed to be cranked.

Stew47 · 06-01-2018, 06:25 AM

So in the end crossroads just forgot The hole. I drilled and put the crank on. Half a crank was pretty tight then turned easy so the motor ran it out fine. I’m not sure if there’s an adjustment issue? Just ran itself in too far? Not sure but hopefully someone will chime in. Just for future though wonder how bedroom slides work?

You may also like: