can't help with the TV but can help with the rest. Look outside your trailer, you will see a panel where your water heater is located. On the 26 BL it is located on the passenger side between the kitchen and bunks. open up that panel and make sure your hot water heater drain plug is screwed in tight ( putting plumbers tape on the threads is a good idea). next look underneath the trailer in that same area. you are looking for 2 plastic nipples that hang down, these are your low point drains (one for hot and one for cold). Open the caps and run the remaining pink stuff out of them and then close. Run the water through all the taps and the toilet until all pink stuff is gone. When inside your trailer look along the wall near the floor for a panel that is screwed on with 4 little screws. it will be right about where you found the drain access panel outside. Open that up and you should find the hot water heater and water pump. once all the pink stuff is out of the lines, flip the valves to let water into the hot water heater. The valves should be currently closed to keep the water/antifreeze out of your hot water heater. Open these and allow this to fill. once it is filled then turn on your hot water heater, you don't want to heat an empty tank as it can burn out your filaments. Also loosening the drain plug to see if the heater is filling is not a good idea. Don't ask me how I learned, er know this.
__________________
2014 Chevy Silverado 3500 SRW Duramax
2011 Zinger ZT26BL-sold
2014 Sabre 34REQS
***Member of the Mason-Dixon Group***
|