I just put in my new P3 assuming my Voyager wasn't outputting enough juice. I don't think it was the controller. I'm getting no where near enough brakes. Found a short between the blue and ground, traced it to the back axel. Cut the wire and I know I'm only braking on the front but with full power and full boost I'm not getting much. Just had the brakes adjusted so that's not the problem. Running through the troubleshoot, darn manual doesn't tell you what you should get, service closed till Monday, I leave Tuesday , will be going through the mountains the next week ending up at the factory rally. My output current is 6.6, output voltage is .12 when pulling lever. Any help would be awesome.
|