Hey folks
Could use a little guidance here. The Dometic fridge that came with our new rig as a sliding stat control. The freezer works like a charm. The inside, best I can get it is 40 degrees. I have a fan on the inside and installed a 12v fan in the service area blowing up. 85CMF.
Ran it over a few days to test each setting, no matter where I slide the temp thingie the temp stays at or around 40 degrees.
Model is DM2852 (I think) There was three numbers in there"
958525633
DM2852RBX
01796221 (serial number)
I was thinking of ordering
http://dinosaurelectronics.com/Dom_adj.htmbut not sure if it will work with my board.
Any thoughts? We are new to Dometic, or last 5er had 5 settings, it was pretty obvious how to make it colder.
RR
Threaded Mode
