Sounds like some investigating is needed. Since this is the first time out this year, it could be rain water that was trapped above the membrane. I would try to isolate any leaks. Fill the water tank and turn on the pump with nothing else open. The pump should not run once it has pressurized. If it does, there may be a leak somewhere. You can also lower the front jacks and see if water still runs out. If that doesn't produce a leak, check all your drain plumbing. Again, with the front of the rig low, flush the toilet and wait. Then run the shower and wait. Do not cut the membrane. It is much better to remove it than to try and repair a cut/tear. Hook up to city water and try the run and wait test again. These can be tough to isolate but then again, it may just be rain water left over from last year. Good luck.
|