Hi all,
My rear Lippert electronic stabilizer jack doesn’t work. It seems like there is no power. I’ve checked the inside fuse and it looks ok. Does anyone have any tips on trouble shooting? Could it be the 6-amp auto-reset breaker? Do they go bad? Any other ideas on determine the fail point would be appreciated.
You probably have some fuses in the front storage compartment. It is covered by a black plastic cover and 2 screws. Mine pops all the time. If not, the switch is bad.
Actually, I found it. However, only my rear jack doesn’t work. That said, if it was the fuse then then both wouldn’t work. If that’s true. How do I trouble shoot the switch or motor?
My trailer landing gears are on separate circuits. If you have a volt/Ohm meter then you could ground to the frame and probe the wires at the switch. My 5th wheel came with a remote. I found that when the switch went bad that the remote still worked. Did you check all the fuses up front?
Figured it out the issue. A loose connection at the junction box near the front. Thanks everyone for the tips. I learned about the fuse up front! Thanks